02Home & Garden · Updated
How to Plant Emerald Green Arborvitae
Short answer
Dig a hole twice as wide as the root ball, plant at the same depth, and water deeply
Emerald green arborvitae (Thuja occidentalis 'Smaragd') are narrow, evergreen privacy trees. To plant them, choose a sunny spot with well-drained soil, dig a wide but shallow hole, set the tree at the same depth it was in the pot, backfill, and water thoroughly. Space them 3 to 4 feet apart for a dense hedge.
What You’ll Need
- Emerald green arborvitae plants (container-grown or balled-and-burlapped)
- Shovel or spade
- Garden trowel (for smaller plants)
- Measuring tape or yardstick
- Water source (hose or watering can)
- Mulch (shredded bark or wood chips)
- Compost or aged manure (optional, for poor soil)
- Gloves (optional, to protect hands)
Step-by-Step
- Choose the right location. Emerald green arborvitae prefer full sun (at least 6 hours of direct sunlight daily) but tolerate partial shade. They need well-drained soil; avoid low spots where water pools. Ensure there’s enough space for the mature size: about 10–15 feet tall and 3–4 feet wide.
- Check soil drainage. Dig a small hole about 12 inches deep and fill it with water. If the water drains within a few hours, drainage is fine. If it stays for more than a day, consider planting in a raised bed or amending the soil heavily.
- Measure the root ball. For container plants, gently remove from the pot and measure the height and width of the root ball. For balled-and-burlapped, measure the burlap ball. The hole should be twice as wide as the root ball and no deeper than the root ball’s height.
- Dig the hole. Use a shovel to dig a hole that is twice as wide as the root ball but only as deep as the root ball itself. The sides of the hole should be rough, not slick, to help roots penetrate the surrounding soil. If your soil is poor, mix the removed soil with compost (up to 50% compost) to backfill.
- Place the tree in the hole. Carefully lower the arborvitae into the hole. For container plants, loosen any circling roots with your fingers. For balled-and-burlapped, remove as much burlap as possible (or at least loosen it from the top). The top of the root ball should be level with the surrounding soil—never bury it deeper.
- Backfill the hole. Fill the hole with the soil you removed (and compost if using), tamping gently to remove air pockets. Do not pack the soil too tightly. Water lightly as you backfill to help settle the soil.
- Water deeply. After planting, water thoroughly until the soil is saturated to the root ball depth. This settles the soil and hydrates the roots. For the first few weeks, keep the soil consistently moist but not soggy.
- Mulch around the base. Apply a 2–3 inch layer of mulch (shredded bark, wood chips) around the tree, keeping it a few inches away from the trunk. Mulch retains moisture, regulates soil temperature, and suppresses weeds.
- Stake if necessary. In windy areas, you may need to stake the tree for the first year. Use two or three stakes and soft ties, but remove them after one growing season.
- Continue watering. For the first growing season, water deeply once a week (about 1–2 inches of water) unless rainfall is sufficient. Reduce frequency in fall to encourage hardening off.
Common Mistakes
- Planting too deep: This is the number one killer. Burying the trunk or the top of the root ball can cause rot and suffocate the roots. Always plant at the same depth as the pot or burlap line.
- Spacing too close: While you want a hedge, planting too close (less than 3 feet) leads to overcrowding, poor air circulation, and increased disease risk. Stick to 3–4 feet for a dense but healthy hedge.
- Overwatering or underwatering: Both extremes stress the tree. Newly planted arborvitae need consistent moisture, but soggy soil can cause root rot. Check the soil moisture a few inches down—if it’s dry, water; if it’s wet, wait.
- Planting in full shade: While they tolerate some shade, too much shade results in sparse, leggy growth and a weaker plant.
- Ignoring soil drainage: Arborvitae cannot tolerate standing water. If your soil is heavy clay, amend it or plant in a raised mound.
Tips
- Plant in early spring or early fall to avoid heat stress and give roots time to establish before winter.
- If you’re planting a hedge, dig a trench instead of individual holes for a more uniform line.
- Water at the base of the plant, not overhead, to reduce foliar disease.
- Fertilize lightly in spring with a balanced slow-release fertilizer, but avoid over-fertilizing which can burn roots.
- For the first winter, consider a windbreak or anti-desiccant spray to prevent winter burn from cold winds.
- Don’t prune in the first year; allow the plant to focus on root growth.
Troubleshooting
If your arborvitae shows browning, wilting, or yellowing after planting, check the following:
- Check soil moisture: Stick your finger 2–3 inches into the soil. If it’s bone dry, water deeply. If it’s soggy, reduce watering and improve drainage.
- Look for planting depth: If the trunk is buried, gently scrape away soil from the base to expose the root flare.
- Inspect for pests: Spider mites and bagworms can attack stressed trees. Look for webbing or small bags on branches. For severe infestations, consult a local nursery or extension service.
- Winter burn: If browning appears in late winter, it may be from cold, drying winds. Water in late fall and consider a windbreak.
- If the tree dies: Remove it and replace with a new one, but first correct the underlying issue (poor drainage, too deep, etc.).
Frequently Asked Questions
How far apart should I plant emerald green arborvitae?
For a dense privacy hedge, space them 3 to 4 feet apart. If you want them to grow as individual specimens, space them at least 6 to 8 feet apart.
Can I plant emerald green arborvitae in the summer?
It’s possible but not ideal. Summer heat and dry conditions stress the tree. If you must plant in summer, water more frequently and provide shade for the first few weeks.
How fast do emerald green arborvitae grow?
They grow about 6 to 12 inches per year, reaching 10–15 feet tall and 3–4 feet wide at maturity.
Do emerald green arborvitae need full sun?
They prefer full sun (6+ hours) but tolerate partial shade. In hot climates, afternoon shade can be beneficial.
How often should I water newly planted arborvitae?
Water deeply 2–3 times per week for the first month, then once a week for the rest of the first growing season, adjusting for rainfall.
Can I plant arborvitae near a fence or wall?
Yes, but leave at least 2–3 feet of space from the fence to allow for air circulation and root growth. Also, consider the mature width of 3–4 feet.
Related
- When Do Leaves Peak in Colorado? Timing Guide
- Why Is It Called Hell’s Kitchen?
- How to Organize Refrigerator Shelves
Further reading: none, this is general know-how. Details can change, so check the official page for anything that matters to you. Spotted a mistake? Tell us. How we write an answer.