Trendingat

02Home & Garden · Updated

How to Unclog a Toilet When Plunger Fails

Short answer

Use a closet auger, hot water, or dish soap to clear the clog

When a plunger fails, the clog is often deeper or harder than usual. Try pouring hot (not boiling) water with dish soap into the bowl, then use a closet auger to break up or retrieve the blockage.

First tryHot water and dish soapExplained in: Step-by-Step
Best toolCloset augerExplained in: Step-by-Step
Watch outNever use chemical drain cleanersExplained in: Troubleshooting
Reading time5 min7 sections, about 1,090 words

What You’ll Need

  • Rubber gloves
  • Bucket or old towels
  • Dish soap (liquid)
  • Hot water (not boiling)
  • Closet auger (also called a toilet auger or plumbing snake)
  • Optional: baking soda and vinegar

Step-by-Step

  1. Put on gloves and protect the floor. Place old towels or a bucket around the base of the toilet to catch any water that might spill. This keeps the area clean and makes the job less stressful.
  2. Remove excess water. If the bowl is full, scoop out some water into a bucket using a cup or small container. You want the water level low enough so you can see the drain opening, but keep enough water to cover the auger tip.
  3. Add dish soap. Squirt a generous amount (about 1/4 cup) of liquid dish soap into the toilet bowl. The soap acts as a lubricant, helping the clog slide through the pipe.
  4. Pour hot water (not boiling). Heat water until it’s hot to the touch but not boiling—boiling water can crack the porcelain. Pour it slowly from waist height into the bowl. The heat and soap can soften and break up a clog made of paper or organic matter. Let it sit for 10–15 minutes.
  5. Try plunging again. After the wait, use your plunger with a few firm, quick thrusts. Sometimes the hot water loosens the clog enough for the plunger to work. If it doesn’t, move on to the auger.
  6. Insert the closet auger. Feed the auger’s coiled cable into the toilet drain opening. You may need to hold the handle and turn it clockwise to push the cable through the trap. Keep going until you feel resistance—that’s the clog.
  7. Rotate and push through. Once you hit the clog, crank the handle to rotate the auger head. This breaks up the blockage or hooks onto it. Push and pull gently to work the auger through the clog. Be patient; it may take a few tries.
  8. Retract and flush. Slowly pull the auger back out, wiping off any debris with paper towels. Then flush the toilet to see if the water drains. If it does, you’re done. If not, repeat the auger process or try the baking soda and vinegar method below.

Common Mistakes

  • Using boiling water. Boiling water can crack the toilet bowl or the wax ring seal, causing leaks. Always use hot tap water.
  • Using chemical drain cleaners. These can damage your pipes, are dangerous to handle, and rarely work on toilet clogs. They also create a hazard if you later need to use an auger.
  • Flushing repeatedly. Each flush adds more water, which can overflow onto the floor. Only flush when you think the clog is cleared.
  • Forcing the plunger too hard. Excessive force can break the toilet’s wax seal or crack the porcelain. Use firm, controlled thrusts.
  • Ignoring the problem. If the clog is caused by a foreign object (like a toy or a wipe), plunging may push it deeper. An auger is safer for retrieving objects.

Tips

  • Use a flange plunger (the one with an inner rubber flap) for better suction on toilets.
  • If you don’t have a closet auger, try a wire coat hanger straightened out to hook the clog—but be careful not to scratch the porcelain.
  • For a natural alternative, pour 1 cup of baking soda and 1 cup of vinegar into the bowl, wait 15 minutes, then flush with hot water. This can help dissolve organic clogs.
  • Always have a plunger and a closet auger on hand—they’re inexpensive and save you from calling a plumber.

Troubleshooting

If the auger doesn’t work, the clog might be too far down the drain or the toilet might have a deeper issue. Try these steps:

  • Check the toilet’s water level. If the bowl fills up but drains slowly, the clog is likely in the trap. If the water rises and then drains on its own, the clog may be in the main sewer line.
  • Use a longer snake. A standard closet auger is about 3 feet long. If the clog is deeper, you may need a longer drain snake (available at hardware stores).
  • Check for a blocked vent. If multiple drains in your home are slow, the issue might be a clogged vent pipe on the roof. This requires a professional.
  • Call a plumber. If you’ve tried everything and the toilet still won’t drain, or if you suspect a main line blockage, it’s time to call a professional. They have specialized equipment like hydro-jetting.

Frequently Asked Questions

Can I use a regular plunger on a toilet?

Yes, but a flange plunger (with an extra rubber lip) creates a better seal and is more effective for toilets. A standard cup plunger may not fit the toilet drain properly.

Is it safe to pour hot water into the toilet?

Yes, as long as the water is not boiling. Hot tap water is safe and won’t crack the porcelain. Boiling water can cause thermal shock and crack the toilet.

What if the toilet overflows?

Immediately stop flushing and turn off the water supply valve behind the toilet. Use towels to soak up the water, and clean with a disinfectant. If the overflow is severe, you may need to call a plumber.

How do I know if the clog is in the main sewer line?

If other drains in your home (sinks, showers) are also slow or gurgling, the clog is likely in the main line. In that case, avoid using any water until you address it.

Can I use a wet/dry vacuum to unclog a toilet?

Yes, you can use a wet/dry vacuum in reverse to blow air into the drain, or in suction mode to pull the clog out. Be careful with water and electricity—keep the vacuum away from water and use a grounded outlet.

How can I prevent future clogs?

Only flush human waste and toilet paper. Avoid flushing wipes (even “flushable” ones), paper towels, feminine products, and cotton balls. These items don’t break down and cause clogs.

Further reading: none, this is general know-how. Details can change, so check the official page for anything that matters to you. Spotted a mistake? Tell us. How we write an answer.