02Home & Garden · Updated
Lawn Mower Surging: Causes & Fixes
Short answer
A lawn mower surges when the engine speed fluctuates due to fuel or air delivery problems
Surging is usually caused by a dirty carburetor, stale fuel, a clogged air filter, or a faulty spark plug. These issues disrupt the air-fuel mixture, making the engine speed up and slow down repeatedly.
What Is Lawn Mower Surging?
Surging is when the engine’s RPM (revolutions per minute) rises and falls rhythmically, often described as “hunting” or “galloping.” You might hear the engine speed up, then slow down, then speed up again, even when the throttle is set to a constant position. This is different from a rough idle or a mower that dies; surging is a distinct, repeating cycle of engine speed changes.
While it can be alarming, surging is rarely a sign of a catastrophic failure. It’s typically a maintenance issue that you can resolve at home with basic tools. Understanding the underlying causes will help you diagnose and fix the problem quickly.
How a Lawn Mower Engine Works
To understand surging, it helps to know the basics of a small gasoline engine. Most walk-behind mowers use a four-stroke engine. The process involves four steps: intake (air and fuel are drawn in), compression (the mixture is compressed), power (the spark plug ignites the mixture, driving the piston down), and exhaust (burned gases are expelled).
For the engine to run smoothly, it needs the correct ratio of air to fuel (typically around 14.7:1). This mixture is prepared in the carburetor, which mixes air and fuel before it enters the cylinder. The carburetor has a small float bowl that maintains a constant fuel level and jets that meter fuel into the airstream. Any disruption to this delicate balance—too much fuel, too little fuel, or a blocked air path—can cause the engine to run erratically.
The engine also has a governor, a mechanical or electronic system that automatically adjusts the throttle to maintain a set RPM under varying loads. When you engage the blades, the governor opens the throttle to keep the engine from stalling. When the load decreases, it closes the throttle. A surging engine often means the governor is overcorrecting because it’s receiving incorrect signals from a poorly running engine.
Common Causes of Surging
Here are the most frequent culprits, in order of likelihood:
- Dirty or Clogged Carburetor: The most common cause. Dried fuel leaves varnish and deposits that block the tiny jets and passages. This restricts fuel flow, causing a lean condition (too much air, not enough fuel) that makes the engine surge.
- Stale or Contaminated Fuel: Gasoline degrades over time, especially with ethanol blends. Old fuel can lose its volatility and absorb moisture, leading to poor combustion and surging.
- Clogged Air Filter: A dirty air filter restricts airflow, creating a rich condition (too much fuel, not enough air). The engine compensates by surging.
- Faulty Spark Plug: A worn or fouled spark plug may not ignite the fuel mixture consistently, causing misfires that the governor tries to correct, resulting in surging.
- Fuel Line or Fuel Cap Issues: A kinked fuel line or a clogged fuel filter can restrict fuel supply. A blocked fuel tank vent (in the cap) can create a vacuum, also restricting fuel flow.
- Vacuum Leak: An air leak in the intake manifold or carburetor gasket can introduce unmetered air, leaning out the mixture and causing surging.
How to Diagnose the Problem
Follow these steps to pinpoint the cause of your surging mower:
- Check the fuel: If the fuel has been sitting for more than a month, drain it and replace it with fresh gasoline. If you use ethanol-blended fuel, consider a fuel stabilizer.
- Inspect the air filter: Remove the air filter and hold it up to a light. If it’s dirty or clogged, replace it (or clean it if it’s foam and reusable). A clean filter is essential for proper airflow.
- Examine the spark plug: Remove the spark plug and check its condition. If it’s black, oily, or has excessive deposits, replace it with a new one. Also, check the gap and adjust it to the manufacturer’s specification.
- Clean the carburetor: If the first three steps don’t solve the problem, the carburetor is likely dirty. You can use a carburetor cleaner spray, but for a thorough cleaning, you may need to remove the carburetor and soak it in cleaner. Pay special attention to the small jets and passages.
- Check fuel lines and cap: Inspect the fuel line for kinks or cracks. Make sure the fuel filter (if equipped) is not clogged. Also, try running the mower with the fuel cap loose. If the surging stops, the cap’s vent is blocked.
Common mistake: Many people immediately assume the carburetor is the problem and replace it without checking the simpler things first. Always start with the cheapest and easiest fixes—fuel, air filter, and spark plug.
How to Fix a Surging Lawn Mower
Once you’ve identified the cause, here’s how to fix it:
- Replace stale fuel: Drain the old fuel and refill with fresh gasoline. Add a fuel stabilizer if you plan to store the mower for more than a few weeks.
- Clean or replace the air filter: A paper filter should be replaced; a foam filter can be washed in soapy water, dried, and lightly oiled.
- Replace the spark plug: Use the type specified in your owner’s manual. Ensure the gap is set correctly.
- Clean the carburetor: Remove the carburetor and disassemble it. Use a carburetor cleaner and compressed air to clear all jets and passages. Reassemble and reinstall.
- Clear fuel lines and cap: Remove any kinks, replace a clogged fuel filter, and clean the fuel cap vent with a small wire or compressed air.
If you’re not comfortable performing these tasks, a small engine repair shop can do it for you. They have specialized tools and experience to diagnose and fix the problem efficiently.
Preventive Maintenance
Preventing surging is much easier than fixing it. A little regular maintenance goes a long way:
- Use fresh fuel: Don’t let gasoline sit in the tank for more than a month. If you do, add a fuel stabilizer.
- Change the oil: Regular oil changes keep the engine clean and running smoothly. Check your manual for the recommended interval.
- Replace the air filter: Check it at the start of each season and replace it if it’s dirty.
- Inspect the spark plug: Replace it annually or as recommended by the manufacturer.
- Run the carburetor dry: Before storing your mower for the winter, run the engine until the fuel in the carburetor is used up. This prevents varnish from forming.
Following these simple steps will keep your mower running smoothly and prevent surging from occurring in the first place.
When to Call a Professional
If you’ve cleaned the carburetor, replaced the air filter and spark plug, and used fresh fuel, but the mower still surges, there may be a more serious issue. For example, a worn governor linkage, a damaged carburetor gasket, or internal engine problems like a stuck valve or worn piston rings could be the cause. These are more complex repairs that require specialized knowledge and tools. In such cases, it’s best to take your mower to a certified small engine mechanic. They can perform a thorough diagnosis and get your mower running smoothly again.
Frequently Asked Questions
Why does my lawn mower surge when the blades are engaged?
When you engage the blades, the engine needs more power to spin them. If the carburetor is dirty or the fuel supply is insufficient, the engine can’t get enough fuel to handle the load, causing it to surge. Cleaning the carburetor and ensuring fresh fuel often resolves this.
Can a bad spark plug cause surging?
Yes, a worn or fouled spark plug can cause misfires, which makes the engine run unevenly. The governor then tries to compensate by adjusting the throttle, leading to surging. Replacing the spark plug is a simple and inexpensive fix.
Is surging bad for my lawn mower?
Yes, surging puts extra stress on the engine and can lead to premature wear. It also means the mower isn’t cutting efficiently. It’s best to address the issue promptly to avoid more costly repairs down the road.
Can I use carburetor cleaner without removing the carburetor?
You can spray carburetor cleaner into the air intake while the engine is running, but this is only a temporary fix. To properly clean the jets and passages, you need to remove the carburetor and disassemble it. Otherwise, the surging will likely return.
What if my lawn mower still surges after cleaning the carburetor?
If you’ve cleaned the carburetor and the problem persists, check for a vacuum leak in the intake manifold or carburetor gaskets. Also, inspect the governor linkage for wear or damage. If those are fine, the issue might be internal, and you should consult a professional.
Related
- LAN Not Connecting? Causes & Fixes
- Why We Celebrate Anzac Day: Meaning & History
- When Does Food Become a Bolus? The Real Answer
Further reading: none, this is general know-how. Details can change, so check the official page for anything that matters to you. Spotted a mistake? Tell us. How we write an answer.